Post time: 15-06-224. Keep the rinse water clean after pickling the steel wire
Post time: 29-08-22Large roll galvanized wire is processed by low carbon steel wire rod, through drawing molding, pickling rust removal, high temperature annealing, cooling and other processes. Large roll galvanized wire electroplating temperature should be controlled in 30-50℃. Because of the strong corrosivity of chloride ions in bath, quartz glass heater is generally used. Continuous production does not need heating, but need cooling cooling.
Because the coating obtained is thicker, hot-dip galvanizing has very good protective function than electric galvanizing, so it is an important maintenance coating for iron and steel parts in strict working environment. Hot-dip galvanized products are widely used in chemical equipment, petroleum processing, Marine exploration, metal structure, electric power transportation, shipbuilding and other occupations. In the field of agriculture, such as pesticide irrigation, greenhouse and construction industry such as water and gas transportation, wire casing, scaffolding, Bridges, highway guardrail and other aspects, it has been widely used in these years.
- Atmospheric relative humidity At the same temperature, the percentage of atmospheric water vapor content and its vapor saturation content is called relative humidity. Below a certain relative humidity, the corrosion rate of metal antirust oil is small, while above this relative humidity, the corrosion rate increases sharply.
As we all know, the purpose of painting the fence fence factory is to make the product better anti-corrosion effect. So what should we pay attention to in the product painting?
Galvanized wire A stable layer of zinc is coated on the outside of the wire, which is used to protect the wire and make the wire service life longer. When producing galvanized wire, the wire is pickled. Pickling is to use some acid mist or acid to wash off some oxides on the surface of iron, that is, rust, and some other corrosive substances, to achieve the purpose of cleaning iron, so that zinc will fall off when galvanizing.
- One end of the wire must be clearly marked and the other end left on the outer layer for easy connection by other wires. Ask the factory to provide the corresponding quality inspection report before packing. Cold drawing is a kind of material often used in our life, especially in the construction of buildings. Cold wire drawing is used more in building materials, cold wire drawing testing standards are also different.
- The surface of alluvium before hot dip galvanizing of orchard special electric galvanized shaft wire can partially remove the surface film layer, surface impurity and other shortcomings according to the basic technology to find and solve; Excessive foam is caused by soap and soapable surface active substances such as human fat into the tank. A moderate rate of foam production would be fine. There are many fine homogeneous particles in the tank, can stabilize the foam layer, with activated carbon mat to remove surface active substances. Or make the bubble unstable according to overworry, these are all reasonable countermeasures; Other strategies should also be used to reduce the amount of surface-active substances introduced. The introduction of organic matter can make the electroplating process speed drop sharply. Although the secret recipe of organic chemistry is beneficial to the high accumulation rate, the thickness of the coating can not meet the requirements after the organic matter is brought in, so the activated carbon can be used to solve the tank.
- Post-plating treatment (passivation, hot melting, sealing and hydrogen removal, etc.) for the purpose of enhancing protective properties, decoration and other special purposes. After galvanized, chromate passivation or other conversion treatment is generally required to form the corresponding type of conversion film, which is one of the key processes to ensure the quality of post-plating.
- The patented technology is used to regularly put zinc blocks into the plating aid pool, so that the bivalent iron in the plating aid becomes trivalent iron, and plays an important measure to stabilize the PH value within a numerical range, and also facilitate the filter to filter out the trivalent iron ions in the plating aid; The trivalent iron ion is controlled between 0.3 and 1.0g/L; When hydrogen is not released in the plating aid, the zinc block is continued. It is an effective measure to reduce zinc slag, improve the fluidity of zinc liquid and reduce the thickness of zinc layer to give full play to the function of plating aid filter.
Select cut silk first to ensure that the raw material of the silk is exactly the raw material you need, the raw material will be used well. Choose high straightness, so that the length of the truncation will be the same, will not show a lot of length difference, the length of the truncated wire is a very important element to choose the truncated wire.
- The common specifications of small hexagonal mesh in production are: the width is 1.22m, and the commonly used width is generally 1m. In terms of length, there are basically no restrictions on small hexagonal nets. 1-100 meters can be produced. The production wire diameter of small hexagonal mesh is generally No. 27 wire to No. 18 wire, and the aperture size is 0.95cm-5.08cm.
- 2. When there are natural barriers such as canals, ponds and lakes on the side of the road, barbed rope protection nets shall not be set up in the section where there is no need to worry about people and livestock entering and illegally occupying the road land.
- 2.0*2.0mm 12 m/kg
- Choose a well-structured crate, such as one with a tray under it so the dog can pee and defecate in it. It’s also easy for the host to clean up.
- The material of wire mesh can choose galvanized wire, stainless steel wire, copper wire, coated wire, lacquer wire, etc., different materials are used in different fields, such as construction, culture, decoration, etc.
Galvanized hook net, is not easy to corrosion, long life protection net. Galvanized hook mesh is durable and easy to install. Wire factory introduction galvanized hook mesh all parts are hot dip galvanized steel to guarantee a 12-year warranty. The frame-structure terminals used to connect the chain links are made of aluminum to maintain the security of free enterprise. The cost of hot-dip galvanizing is low, and the cost of hot-dip galvanizing is lower than that of other anti-rust treatment.
- 2, see if solder joint is firm, net width on both sides of whether level off, the wire have broken wire phenomena (note: net length is the length of the wire), welded wire mesh of the solder joint is normal after precise voltage debugging, welding of welded wire mesh with graphite, strong, and the net width on both sides of the cutting time is according to the broken wire knife to ensure smooth on both sides, There will be no leakage cutting on both sides of the protrusion of the wire is not cut off the phenomenon, the wire is broken, because the wire is not used up even if the column hole is blocked by the wire can not enter the normal cause, such as broken phenomenon can appear on the surface of the electric welding network lack of a wire.
- Welded wire mesh can be made into mesh form, the net surface jinsu or coating process, can be used in welded wire mesh and surface to form a layer of protective film, can effectively make the wire with the outside world with water or corrosive substances isolation, can achieve the effect of growth time, also can make the mesh surface present a different color, make the mesh to achieve the effect of beautiful. After the dip plastic mesh is usually used for outdoor, and column links, can play a protective effect against theft.
Post time: 30-12-22Some customers may not use the blade rope immediately when they buy it. Some are for retail and some are temporarily without the blade rope for site construction. At this time, customers need to follow up the characteristics of the blade rope for storage.
Post time: 07-06-24- Take 20cm galvanized wire for acid fog experiment, check the zinc content of galvanized wire through the balance to see whether it meets the zinc layer standard required by the customer, ensure that the metal wire can achieve the role of rust and corrosion prevention, and meet the service life required by the customer. Galvanized iron wires must be packed in good condition, bound neatly and orderly, and bound with an inward end to prevent scratches during transportation. The inspection standard of galvanized iron wire also includes the tensile test. This item is determined according to the material of the galvanized wire order ordered by the customer, and it needs to be tested by comparing the raw material list.
Electric galvanized wire is dipped in the zinc solution of heating ablation, the production speed is fast, the coating is thick but not uniform, the market allows a low thickness of 45 microns, up to 300 microns or more. The color is dark, the zinc metal is consumed, and the matrix metal is formed into the entry layer, the corrosion resistance is good, and the outdoor environment of hot dip galvanized can adhere to decades.
- In the process of using hot-dip galvanized wire, we should do a good job of daily overhaul and maintenance, try to avoid the destruction of the surface galvanized layer, and extend the service life of the wire. In addition to user binding, building special electric galvanized shaft silk production factory can also be used to decorate gardens and buildings, make it more beautiful and have higher taste.