m16 concrete anchor

The installation process of chemical anchors involves drilling a suitable hole into the substrate, followed by the insertion of the anchor. The resin and hardener are then mixed, usually in a pre-determined ratio, and poured into the anchor sleeve or directly into the hole. As the mixture cures, it expands and fills any voids, creating a tight grip on the surrounding material. This chemical bonding not only ensures superior load-bearing capabilities but also provides resistance to vibration, corrosion, and temperature fluctuations.

...

The installation process of butterfly wall plugs is straightforward and requires minimal tools. First, choose the appropriate size plug based on the weight of the item to be hung and the thickness of the plasterboard. Then, drill a pilot hole slightly smaller than the plug's diameter Then, drill a pilot hole slightly smaller than the plug's diameter Then, drill a pilot hole slightly smaller than the plug's diameter Then, drill a pilot hole slightly smaller than the plug's diameterbutterfly wall plugs for plasterboard. Next, insert the plug into the hole, gently tapping it in with a hammer until it is fully seated. Finally, screw in the accompanying screw, which will cause the wings to spread and lock the plug securely in place.

...

The process of installing concrete anchor bolts is quite straightforward. First, the location for the bolts is marked on the concrete surface. This is typically done using a drill bit that matches the diameter of the anchor bolt. Once the holes are drilled, the bolts are inserted into the holes and tightened to a specific torque to ensure a secure fit. The bolts are then covered with grout, which hardens over time to create an even stronger bond between the bolt and the concrete.

...