double ended thread

When using 50 mm chipboard screws, it's essential to pre-drill holes to prevent splitting and to guide the screw for straight insertion. The pre-drilled hole should be slightly smaller than the screw's shank to allow for a tight fit The pre-drilled hole should be slightly smaller than the screw's shank to allow for a tight fit The pre-drilled hole should be slightly smaller than the screw's shank to allow for a tight fit The pre-drilled hole should be slightly smaller than the screw's shank to allow for a tight fit50 mm chipboard screws. It's also advisable to use a screwdriver or drill with a clutch setting to prevent over-tightening, which could damage the board or strip the screw threads.

...

A shear stud bolt is essentially a steel rod with a head on one end and a threaded end for anchorage. They are typically used in composite beams and floors where they act as connectors between the steel beam and the concrete slab. The term shear refers to the force that tends to slide one part of a structure over another, perpendicular to the direction of the force. In such scenarios, shear studs serve as a critical line of defense against these potentially damaging forces.

...