Titanium dioxide goes into many industrial and consumer products. It makes paper white and bright, it keeps plastics and rubber soft and flexible, and helps remove harmful emissions from car exhaust, among many other uses. In the drug industry, it's a key ingredient in pill capsules and tablet coatings to keep the medicine inside from being affected by sunlight. 

When choosing a wholesale supplier for anatase titanium dioxide, it's important to consider factors such as quality, consistency, and reliability. Look for suppliers who have a proven track record of delivering high-quality products on time and in full. It's also a good idea to inquire about the supplier's manufacturing processes and quality control measures to ensure that the titanium dioxide meets industry standards.

A great number of other brands with fancy names have gone out of the German market, because of some defects in the processes of manufacture. The English exporters, as a rule, offer three or four grades of lithopone, the lowest priced consisting of about 12 per cent zinc sulphide, the best varying between 30 and 32 per cent zinc sulphide. A white pigment of this composition containing more than 32 per cent zinc sulphide does not work well in oil as a paint, although in the oilcloth and shade cloth industries an article containing as high as 45 per cent zinc sulphide has been used apparently with success. Carefully prepared lithopone, containing 30 to 32 per cent sulphide of zinc with not over 1.5 per cent zinc oxide, the balance being barium sulphate, is a white powder almost equal to the best grades of French process zinc oxide in whiteness and holds a medium position in specific gravity between white lead and zinc oxide. Its oil absorption is also fairly well in the middle between the two white pigments mentioned, lead carbonate requiring 9 per cent of oil, zinc oxide on an average 17 per cent and lithopone 13 per cent to form a stiff paste. There is one advantage in the manipulation of lithopone in oil over both white lead and zinc oxide, it is more readily mis-cible than either of these, for some purposes requiring no mill grinding at all, simply thorough mixing with the oil. However, when lithopone has not been furnaced up to the required time, it will require a much greater percentage of oil for grinding and more thinners for spreading than the normal pigment. Pigment of that character is not well adapted for use in the manufacture of paints, as it lacks in body and color resisting properties and does not work well under the brush. In those industries, where the paint can be applied with machinery, as in shade cloth making, etc., it appears to be preferred, because of these very defects. As this sort of lithopone, ground in linseed oil in paste form, is thinned for application to the cloth with benzine only, and on account of its greater tendency to thicken, requires more of this comparatively cheap thinning medium, it is preferred by most of the manufacturers of machine painted shade cloth. Another point considered by them is that it does not require as much coloring matter to tint the white paste to the required standard depth as would be the case if the lithopone were of the standard required for the making of paint or enamels. On the other hand, the lithopone preferred by the shade cloth trade would prove a failure in the manufacture of oil paints and much more so, when used as a pigment in the so-called enamel or varnish paints. Every paint manufacturer knows, or should know, that a pigment containing hygroscopic moisture does not work well with oil and driers in a paint and that with varnish especially it is very susceptible to livering on standing and to becoming puffed to such an extent as to make it unworkable under the brush. While the process of making lithopone is not very difficult or complicated, the success of obtaining a first class product depends to a great extent on the purity of the material used. Foreign substances in these are readily eliminated by careful manipulation, which, however, requires thorough knowledge and great care, as otherwise the result will be a failure, rendering a product of bad color and lack of covering power.

Since then, there has been a few animal studies suggesting titanium dioxide is connected to cancer. A 2017 study in Scientific Reports, for instance, found that rats with titanium dioxide in their diet had impaired immune systems, which could contribute to autoimmune diseases and colorectal cancer.

The author thanks Marco Leona, Scientist-in-Charge of the Department of Scientific Research at the Metropolitan Museum of Art for conducting fluorescence spectrometry on Wheel of Fortune and a valuable discussion of the research, as well as Silvia Centeno, Research Scientist at the Metropolitan Museum of Art, who performed Raman analysis on the watercolors and also contributed her insight. The phenomenon of the phosphorescing lithopone was originally discovered during the author's fellowship in the Sherman Fairchild Center for the Conservation of Works on Paper, funded by the Andrew W. Mellon Foundation. The author thanks all her colleagues for their ideas and support during the research of this paper, and special thanks to Rachel Mustalish for her assistance in editing this work.

No. EFSA’s role was limited to evaluating the risks linked to titanium dioxide as a food additive. This included an assessment of relevant scientific information on TiO₂, its potential toxicity, and estimates of human dietary exposure. Any legislative or regulatory decisions on the authorisations of food additives are the responsibility of the risk managers (i.e. European Commission and Member States).

Tint reducing power, compared with standard samples

Titanium dioxide, or TiO2, will be listed on product labels, but companies are not required to list ingredient size or structure. When it is used in sunscreens to block UV light, titanium dioxide is considered an active ingredient, which means the concentration must also be listed.