4. Improved Installation With the ability to drill through thick steel, Tek screws can be driven directly into the material without the need for cumbersome equipment. This simplicity enhances overall productivity on the job site.
Most often, they are coated with zinc or a combination of zinc and phosphate, providing resistance against corrosion and increasing their longevity Most often, they are coated with zinc or a combination of zinc and phosphate, providing resistance against corrosion and increasing their longevity20mm chipboard screws. This coating not only enhances the aesthetic appeal but also protects the screw from rust, especially in humid environments.The large hexagonal mesh is called the stone cage net. Stone cage net before delivery, must be folded into a simple surface, packed compressed after delivery. Then put it in the right position to open, and then the block diameter suitable stone into the cage, the cover is tight, and then the various stone cage net and the adjacent stone cage net tied up.
After the optimization of the process, mass production of 0.80mm electro galvanized steel wire electro galvanized zinc layer quality is controlled within 80 ~ 90g/m2, zinc layer quality dispersion is very small; The results show that the average weight of zinc layer is 14.5g/m2, the loss of zinc layer is less than 5%, and the tensile strength of steel wire is 2300 ~ 2500MPa. It not only effectively controls the quality of zinc layer of raw steel wire, but also reduces unnecessary waste and production cost.
Wire mesh even in the mining industry also has a higher reflection, because the selection of low-carbon materials to do the material so that it has a general iron net class does not have flexibility, concluded that its plasticity in use, and then can be used in hardware crafts deep processing production, as the wall plastering, leak prevention crack and so on. Its light net body, lower cost, more can let customers experience its economic benefits.
Each coil of steel wire shall consist of one wire. The surface of the rod shall not have cracks, folds, scars, ears, layers or inclusions. However, indentation, pits, bumps, scratches and pockmarks are allowed, and the depth or height shall not be 0.2mm. There should be no corrosion and oxidation skin on the surface of the steel wire, and oxidation color is allowed by heat treatment. The surface of the wire is allowed to have scratches not exceeding half of the allowable deviation range of the diameter, and local defects not exceeding the allowable deviation of the appropriate diameter.
Select cut wire first of all to ensure that the raw material of the silk is exactly the raw material you need, the raw material to ensure that it will be used well. Choose the straightness is relatively high, so that the length of the truncation will be the same, there will not be a lot of length difference, the length of the truncated wire is a very important element to select the truncated wire.
1. Choose according to your dog’s size
