Risk managers at the European Commission and in EU Member States have been informed of EFSA’s conclusions and will consider appropriate action to take to ensure consumers’ protection.

TiO₂ comes in many different forms. However, only a few of these forms are considered food-grade (acceptable to be added to food). Many studies that raised concern about the safety of TiO₂, including the concern for genotoxicity, used forms of TiO₂ that are not considered acceptable for use in food and have different properties than food-grade TiO₂. Other studies did use food-grade TiO₂, but took steps to break the material down into smaller particles than what would normally be found in food.

The produced barium sulfide enters the leacher, and the temperature is controlled above 65°C to obtain a barium sulfide content of 70%, and then enters the clarification barrel, add zinc sulfate for reaction after clarification, control the zinc sulfate content to be greater than 28%, pH=8~9, and obtain a mixture of barium sulfate and zinc sulfide with a density of 1.296~1.357 g/cm3.

Although the evidence for general toxic effects was not conclusive, on the basis of the new data and strengthened methods we could not rule out a concern for genotoxicity and consequently we could not establish a safe level for daily intake of the food additive, commented Matthew Wright, member of the EFSA's Food Additives and Flavourings Panel in a press statement.

So, what does it all mean for you, the consumer? Should you stop eating Skittles or begin checking foods for the presence of titanium dioxide? Here's a closer look.

2. Cosmetics

Drivers

Lithopone or sulphide of zinc white has been in general use for twenty years or more in many industries where a white pigment of considerable body or hiding power is required that is not subject to change like lead carbonate and has not the brittle character of zinc oxide, besides being sold at a lower figure than either of these. Nevertheless it is still comparatively new to the general painting trade. Because of our tariff protection its manufacture in this country has made great progress. Yet in spite of this and the duty imposed on it, the imports are still in excess of the quantity manufactured here. A short history of its origin will no doubt prove of interest to our readers.

Below 20% substitution, it is recommended to replace 1 kg of TiO2 with 1 kg of Lithopone.  

The following aspects have been covered in the lithopone manufacturing plant report:

One of the key challenges facing TiO2 industry suppliers is the fluctuation of raw material prices. The production of TiO2 requires raw materials such as ilmenite or rutile, which are subject to market price volatility. Suppliers must carefully monitor these fluctuations and adjust their production processes accordingly to ensure profitability.