ERIKS type M (type B according to the DIN standard) has a single metal casing and rubber sealing lip. Since the casing is made of metal, it must be fitted in a well-finished, undamaged groove. Large volumes of oil seals with metal casings are often cheaper, which is why they are often used as original equipment in machines. However, if an oil seal has to be replaced, types with a rubber exterior (type R or RST) are easier to fit. Type MST is similar to M and commonly used. The difference is the dust lip in the MST oil seal that prevents dust and dirt reaching the sealing lip, and extends its service life in dusty environments.

This is one of the frequent reasons for oil seal failure, and this is majorly because of the volatility of any of the elastomer’s constituents. These causative constituents may be part of the elastomer formulation, or gases that got entrapped in the elastomer during the molding process. The deceiving fact about this failure is that sometimes the oil seal won’t show any visual sign of out-gassing, however, sometimes when the out-gassing is extreme, they shrink.

Heat resistance

Once you have selected the most suitable seal available, considering the environment, temperature, shaft speed, pressure, lubrication availability, as well as the size, of course, the seal should be stored adequately and then fitted properly. Here are a few suggestions that could help:-