Market Dynamics

Lithopone B301, Lithopone B311 powder is also widely applied in paints and enamels

Lithopone, white powder, relative density: 4.136 ~ 4.39 g / mL, insoluble in water. It is a mixture of zinc sulfide and barium sulfate. Inorganic white pigment, widely used in plastics such as polyolefin, vinyl resin, ABS resin, polystyrene, polycarbonate, nylon and polyoxymethylene, and white pigments of paints and inks. It is less effective in polyurethane and amino resins and less suitable in fluoroplastics. It is also used for coloring of rubber products, paper, varnish, tarpaulin, leather, watercolor paint, paper, enamel, and the like. Used as a binder in the production of electric beads.

CSPI’s Chemical Cuisine is the web’s definitive rating of the chemicals used to preserve foods and affect their taste, texture, or appearance. Besides titanium dioxide, the group recommends avoiding artificial sweeteners like aspartame, acesulfame potassium, and sucralose, as well as synthetic food dyes like Yellow 5 and Red 3. CSPI and others have recently asked the Food and Drug Administration to ban the latter dye in foods and ingested drugs because the FDA has already determined that it is a carcinogen unsafe for use in cosmetics.

Oil absorption, g/ 100g

Natural barite and anthracite containing more than 95% barium sulfate are mixed and fed at a ratio of 3:1 (mass). After being crushed to a diameter of less than 2cm, it enters the reduction furnace. The furnace temperature is controlled to be 1000-1200°C in the front section and 500-500 in the back section. 600°C, the reduction furnace rotates at a speed of 80 seconds per revolution, and the reaction conversion rate is 80% to 90%.

Another challenge facing TiO2 industry suppliers is the increasing environmental regulations and sustainability requirements. The production of TiO2 can have environmental impacts, such as energy consumption and waste generation. Suppliers must invest in sustainable practices and technologies to minimize their environmental footprint and meet regulatory requirements.

Item

Stability and darkening

Where It’s Hiding

Total zinc and barium sulphate

Hemolysis was studied on suspensions of P25TiO₂NPs (0.2 mg/mL and 0.02 mg/mL), vitaminB2@P25TiO₂NPs (0.2 mg/mL and 0.02 mg/mL) and vitamin B2 (0.2 mg/mL and 0.02 mg/mL) were prepared and mixed with 500 μL of anticoagulated blood (donated by Laboratorio de Hemoderivados, UNC) in a rate of 1/10. A solution of NaCl 10% was used as the positive control and PBS as the negative control. Then, the samples were irradiated using the LED described above for 3 and 6 h to simulate the light penetration into the skin. Also, a set of samples was kept in the dark as control. Finally, the samples were centrifuged and the absorbance at 540 nm was measured in the supernatants. The experiment was reproduced twice; the standard deviation was calculated and p-value < 0.05 were considered significant.

Histoire