double sided stud bolt

The 'full-threaded' part of the name implies that the entire length of the rod is threaded, from end to end. This design offers several advantages over partially threaded rods. It allows for maximum engagement with nuts or tapped holes, providing superior holding power and load distribution. Additionally, full threading provides more flexibility in adjusting the length of the assembly, as the rod can be cut to size without losing any thread engagement area.

...

When using 50 mm chipboard screws, it's essential to pre-drill holes to prevent splitting and to guide the screw for straight insertion. The pre-drilled hole should be slightly smaller than the screw's shank to allow for a tight fit The pre-drilled hole should be slightly smaller than the screw's shank to allow for a tight fit The pre-drilled hole should be slightly smaller than the screw's shank to allow for a tight fit The pre-drilled hole should be slightly smaller than the screw's shank to allow for a tight fit50 mm chipboard screws. It's also advisable to use a screwdriver or drill with a clutch setting to prevent over-tightening, which could damage the board or strip the screw threads.

...