Galvanized steel pipe is divided into hot dip galvanized and electric galvanized. The layer of hot dip galvanized is thick, the cost of electric galvanized is low, and the surface is not very smooth. Used for steel blowing oxygen pipe, generally with small diameter welded steel pipe, specifications from 3/8-2 inches of eight. Made of 08, 10, 15, 20 or 195-Q235 steel strip, in order to prevent corrosion, some should be aluminized.
- If the connection near the installation is not completely aligned, then the installation has been aligned, and then the rest of the attachment installation, it will be relatively simple, and then install the blade thorn rope, installation of blade thorn rope must be the blade thorn rope with a clip card below the guardrail. And this will not damage the purse Seine, after the installation of the accessories, the guardrail is also equal to the installation, and then check the fixing of the screws, to determine that there is no problem after.
- 2, galvanized silk mesh forming sheet storage ground should be flat, according to the symbolic needs of regular accumulation, height should not exceed 2M, and away from heat source, avoid exposure.
- Hot dip galvanizing is in the hot melt zinc liquid dip plating, production speed, thick but uneven coating, the market allows the thickness of 45 microns, up to 300 microns above. It is dark in color, consumes more zinc metal, forms infiltration layer with base metal, and has good corrosion resistance. Hot dip galvanizing can be maintained for decades in outdoor environment. The protection of zinc coating on iron matrix has two principles: on the one hand, although zinc is more active and easy to oxidize than iron, but its oxide film is not as loose and compact as iron oxide. The dense oxide layer formed on the surface inhibits the further oxidation of zinc in the interior.
In order to pack and bind galvanized wire in the surface of the sedimentary layer to local removal of surface film, surface inclusion and other defects can be found and treated by conventional technology; Excess foam is formed when soap and surfactants such as saponified fats are brought into the tank. Moderate rates of foam formation may be harmless. Small, homogeneous particles of large denier present in the bath can stabilize the foam layer. Use activated carbon mat to remove surface active substance. Or through filtration to make the foam is not too stable, which are effective measures; Other measures should also be taken to reduce the amount of surfactant introduced. The electroplating speed can be obviously reduced by the addition of organic matter. Although chemical formulations facilitate high deposition rates, the deposition of organic matter does not meet the requirements of coating thickness, so activated carbon can be used to treat the bath.
Post time: 17-06-22Benefits of using a pet cage:
- Galvanizing refers to the surface treatment technology of plating a layer of zinc on the surface of metal, alloy or other materials to play the role of aesthetics and rust prevention. The main method used now is hot galvanizing. However, hot dip galvanizing industry has been developed with the rapid development of cold strip rolling in the past 30 years. The production process of hot-galvanized sheet mainly includes: raw plate preparation → pre-plating treatment → hot-dip plating → post-plating treatment → finished product inspection and so on.
- Great attention should be paid to pickling of large rolls of galvanized wire. Acid is highly corrosive. Therefore, when adding acid, the acid must be poured into the water, and it is along the wall of the cylinder, and not thrown down at once, so as not to cause splashing. Remember the order of acid pouring, acid into water rather than water into acid, water into acid will cause splashing and boiling, when pouring acid must wear protective glasses, beside must ensure that there are no non-professional people watching, so as not to cause some acid splashing danger.
Dog cage mainly to welding, spraying, injection molding, electroplating surface treatment, dog cage using high quality steel wire, dog cage surface treatment are spray, plastic, electrophoresis, chrome plating, galvanized, imitation gold, etc., can be processed according to customer requirements, can also be customized, the structure of the dog cage compact assembly, clean and beautiful appearance, make folding and dismantling cage more convenient and quick, will not take up too much space.
- But there are some necessary precautions in the production of galvanized wire. Remove all tools and piles on the work site and equipment that hinder activities, and slowly put the wire into the cylinder during pickling to prevent acid splashing on the body. When adding acid, the acid must be slowly poured into the water. Do not pour water into the acid to prevent acid spillage and injury. Workers should wear protective glasses when working. Then in the handling of wire and other items, it is strictly prohibited to push hard.
- And the role of wire mesh in the exterior wall plastering if from an Angle of anti-falling method, the effect of anti-cracking is relatively small, because of the azimuth problem; And about the external insulation system is used in the brick veneer, as for the role should also be anti-drop followed by anti-cracking, so we should choose the grid 10×10×0.6, these are some experience selection, the conversion of the grid comes from the national standards of steel wire mesh, the selection of steel content of the grade conversion.
- 2, galvanized silk mesh molding sheet storage ground should be flat, according to the symbolic needs of regular accumulation, height should not exceed 2M, and away from the heat source, avoid exposure.
Post time: 21-03-23Because the coal resources are exposed on the surface of the open pit coal mine, it is more important to protect and prevent coal theft. The erection and use of barbed rope in these places are better than other products. The barbed rope factory recommends suitable barbed rope products to everyone.
- The most obvious gap in a short period of time is the cross section of this piece, hot dip galvanized wire because it is surface anti-corrosion treatment, so in the cross section of this piece will appear rust, and stainless steel wire because the internal raw materials and surface raw materials are consistent, so there is no such situation.
- Plastic spraying is also known as electrostatic powder spraying. It is the use of electrostatic attack device to make plastic powder charged, adsorbed on the surface of the iron plate, and then through the baking of 180~220℃, so that the powder can be melted and adhered to the metal surface. Plastic spraying products are mostly used in the indoor box, and the paint film appears flat or matte. Spray powder mainly acrylic powder, polyester powder and so on.
It’s not clear why friends would want to use building nets for floor heating. What are its advantages in the floor heating project, the role of steel wire mesh is convenient for construction. Building mesh can better fix the pipe, conducive to the construction of the floor, improve efficiency. Anti crack function. The building network can improve the bearing capacity of the foundation of the thermal insulation board, the thicker the diameter of the steel wire of the building, the greater the bearing capacity, effectively prevent the appearance of cracks and cracks of steel wire mesh can improve the thermal shrinkage and contraction of cement, strengthen the tensile strength of cement, improve the quality of the heating project.
There is also a straight blade stabbing rope, which is mainly because the board and wire are not wound in the process of wrapping, so the blade stabbing rope produced is a straight product. The length of the barbed rope of this specification cannot be too long due to the limitation of logistics, and it cannot be bent because it is easy to be deformed by force. This is also the main reason why the barbed rope of the straight blade is not whole or long. Customers are advised to determine the spacing before purchase to prevent losses caused by no calculation.
Post time: 29-04-22The production process of large rolls of galvanized wire is a level of drawing, through the mold into a slightly smaller diameter than the original. And so on down to the desired length. One pull is not desirable, must be numbered, from coarse to fine is dependent on metal ductility. If it changes too much it just breaks. After drawing to a certain diameter, galvanized, so that the finished product.
1. The diameter of raw materials and the thickness of the diameter have a direct impact;