Fluid Types - Various oil seals are able to withstand interactions with oils, fuels, grease, water and more. Knowing what type of fluid the rotary shaft seal will be in constant contact with will ensure the longevity of the seal and surrounding components.

FKM or FPM, which is in well-known brand Viton™, can withstand higher liquid temperatures of up to 180 ˚C. FKM is highly resistant to strong acids and bases, as well as to synthetic oils and greases. Glycol-based oil and grease, however, can also damage FKM.

ERIKS type R (type A according to the DIN standard) is identical in shape to type M, but has a rubber outer case with metal reinforcement on the inside. The rubber creates a good seal in the housing, even if the housing has suffered minor damage or is not in its best condition for other reasons. The RST version has a dust lip. These types are often chosen to replace a type with a metal outer case because they are easier to install and can cope with minor damage to the groove, such as scratches.

They are best known for their bright light emission that is far reaching. Their tungsten is encased in a quartz tube filled with xenon gas. They may require more power when turned on but use much less of it to maintain brightness. Moreover, they have a longer lifespan compared to the halogens. They may seem better but they also present some limitations such as being more expensive as far as manufacturing and replacement is concerned. They are not easy to manufacture from their complex design. Their bright light cause a blinding effect to oncoming traffic which is undesirable and can cause dangers on roads.

Carefully lower the sump from the crankcase.

Cassette Seals
 

1. Sealing Element

There is a little leakage as the fluid vapors get released into the atmosphere from the faces of the seal, though. Since the quantity is hardly quantifiable, the seals are considered leak proof.

When you start the actual installation make sure that the oil seal is always facing the right direction. So, not facing outwards, but always with the spring facing the side of the medium to be sealed. The oil seal must then be pressed into the bore. Use appropriate tools, such as a bearing fitting tool set, to ensure that this is done evenly. The oil seal must never be forcefully hammered into the bore.