Testing samples were made mixing 100 uL of TiO₂NPs suspensions (0.2 mg/mL and 0.02 mg/mL) and vitamins@P25TiO₂NPs (0.2 mg/mL and 0.02 mg/mL) with 100 μL ATCC 29,213 methicillin-sensitive Staphylococcus aureus (MSSA) (10⁷ in PBS, pH 7). Controls were made replacing nanoparticles with the same volume of PBS. The concentrations of nanoparticle suspensions were chosen based on the FDA approved maximal and the minimal amount usually found in sunscreens, which are 20% and 2% (this is equivalent to 0.2 mg/mL and 0.02 mg/mL for nanoparticles suspensions). The cream concentration, on the other hand, was an intermediate value of 10%.

Journal Information

ROS were detected through the colorimetric assay employing the nitro-blue tetrazolium salt (NBT salt) by reading the absorbance of the reduced blue molecule.

The calcined product obtained by the ordinary zinc-barium white preparation method is beaten into a slurry, which is then surface-treated with sodium silicate, aluminum sulfate or sodium aluminate and surfactant, and then filtered, washed, dried and pulverized. Can.

Having thus described the origin and uses of the pigment, we now come to the question, what is lithopone? It is, in short, a chemical compound usually consisting of 30.5 per cent zinc sulphide, 1.5 per cent zinc oxide and 68 per cent barium sulphate, but these proportions vary slightly in the different makes. Lithopone of this composition is sold as the highest grade, either as red seal or green seal, as it best suits the idea of the manufacturer. Many manufacturers, especially in Europe, sell and also export other brands under other seals, containing 24, 20, 18 and as little as 12 per cent of zinc sulphide with very small percentages of zinc oxide, the balance being usually barium sulphate, but sometimes certain portions of China clay or gypsum (calcium sulphate) or whiting (calcium carbonate). Such brands are not a chemical compound, but mechanical mixtures of the chemically compounded lithopone and the admixtures referred to.

The natural barite containing more than 95% of barium sulfate is mixed with anthracite in a ratio of 3:1 (mass), and is pulverized to a diameter of about 2 cm or less to enter a reduction furnace, and the front stage of the furnace temperature is controlled by 1000 to 1200 ° C, and the latter stage is 500 to 600 ° C, the reduction furnace rotates at a speed of 80s per revolution, the reaction conversion rate is 80% to 90%, the obtained barium sulfide enters the leaching device, the control temperature is above 65 ° C, and the content of barium sulfide is 701%, and then enters the clarification. The barrel is clarified and then added with zinc sulfate to control the zinc sulfate content to be greater than 28%, and the pH is 8-9, and a mixture of barium sulfate and zinc sulfide having a density of

Titanium dioxide (TiO2) is a chemically inert inorganic compound and an insoluble white solid that occurs naturally in several minerals, including rutile, anatase, and brookite. It is created synthetically from the mineral ilmenite. It is an insoluble white solid. Anatase, when compared to brookite and routine, has the most industrial applications, but it is the most toxic form of TiO2.