self drilling nylon drywall anchors

Did not do the adhesion test of powder spraying or fluorocarbon spray on the packaging galvanized wire, but there are two points for reference: one, in the sealed or air circulation environment, non-metallic volatiles can corrosion zinc coating; Second, zinc above 230 degrees (c) will brittle the base metal. After powder spraying and fluorocarbon spraying, it is necessary to bake at a higher temperature and in a sealed environment, causing rapid corrosion of zinc, resulting in loose corrosion film resulting in decreased adhesion of coating, and even leading to brittle situation of steel wire.
Ring corn with: used as a ring corn net, generally use mesh 5cm*7cm or 5cm*5cm of the original galvanized welding net, wire diameter from 1.8mm-2.3mm, height of 1.2m – 1.8m.
Post time: 26-05-23
The iron is clean and clean, and then solvent treatment, after drying immersed in zinc liquid, iron and molten zinc reaction to produce an alloyed zinc layer, the process is: degreasing – washing – pickling – assisted plating – drying – hot dip galvanizing – separation – cooling passivation. The thickness of the alloy layer of hot plating wire mainly depends on the chemical composition of the steel silicon content, the size of the steel cross-sectional area, the roughness of the steel surface, the temperature of the zinc pot, the time of dipping zinc, cooling speed, cold rolling deformation, etc.
When the large roll galvanized wire galvanizing process coating foaming, first check the bath temperature. If the bath temperature is not low, then strengthen the plating before removing oil, prevent the matrix metal in acid corrosion. If you pay attention to these problems, the foaming phenomenon still exists, it should pay attention to the amount and quality of additives, then you can stop adding additives, with high current electrolysis for a period of time, in order to reduce the content of additives, observe whether the foaming phenomenon is improved. If there is still no improvement, it is necessary to check whether the storage period of additives is too long, or whether there are too many impurities in the additives.
Post time: 08-09-22
There is also a straight blade stabbing rope, which is mainly because the board and wire are not wound in the process of wrapping, so the blade stabbing rope produced is a straight product. The length of the barbed rope of this specification cannot be too long due to the limitation of logistics, and it cannot be bent because it is easy to be deformed by force. This is also the main reason why the barbed rope of the straight blade is not whole or long. Customers are advised to determine the spacing before purchase to prevent losses caused by no calculation.
Post time: 28-03-23
In the selection of birdcage, the characteristics of the birds, the way of daily management, the impact of the surrounding environment and so on should be considered. Therefore, it is necessary to have requirements on the shape, structure and technology of the cage, so that the cage can not only be suitable for the birds’ activities, but also delicate and beautiful.
In our daily life, we are certainly familiar with the construction of power grid. Choosing such special barbed rope can improve the safety factor of the entire power grid during construction. In fact, after the construction of the power grid does not need to be energized, the only security measures can play the equipment is these galvanized barbed rope, in the choice of time is certainly to choose some of their own needs, and the quality of the product of reliable materials.
The distance between the adjacent two thorn rope installation do not know whether you have noticed? Careful observation can find that its spacing is not the same, the thorn rope factory for customer consultation when asking the installation height of the reason.
Uses: used in industry, agriculture, animal husbandry, highway, forest protection
Post time: 14-04-23
Post time: 28-06-22
Zinc pot workers should be determined to do duty and responsibility. Do not leave the post without leave, always observe the change of hot plating wire galvanized layer, and according to the analysis results, master the asbestos block gap friction, how long it takes to press, replace the pressing face; Adjust the working face; Until all four faces of the asbestos block are used up, maintenance workers can continue to use the asbestos block after repair when necessary to reduce the consumption of asbestos block.
Hexagonal cage has a wide range of applications, with the progress of science and technology, has been extended to the major hydraulic engineering, civil engineering. Geotechnical engineering and other projects. In the hydraulic hexagonal cage in the river construction to reach the utility, that is appropriate and the use of hexagonal cage used to fill stone, fixed river, can avoid river erosion bring water and soil loss. In the civil engineering project, the hexagonal cage is considered appropriate and the use of similar particle size volume particle filling, cage between the formation of a mesh wall, which is the stone cage mesh retaining wall.
Galvanized wire to galvanized uniform, a body is now its cross section, the second is the longitudinal uniformity. In the actual operation process, such as the jitter of steel wire, the surface of the pot scum and other reasons will cause galvanized wire surface galvanized layer accumulation, should try to solve the problem.
The galvanized layer forms a special metallurgical structure that can withstand mechanical damage during transportation and use. Selection of low carbon raw materials, through wire drawing, annealing processing, soft and strong tensile resistance. Finished products coated with anti-rust oil, not easy to rust, according to customer requirements into bundles, each bundle of 1-50Kg, can also be made into U-shaped wire, broken wire, internal plastic and external hemp packaging, mainly used for binding silk, construction silk, etc.
Post time: 14-12-22
Thorn rope factory can not only have one type of product when processing thorn rope, a variety of models can meet the protection needs of different customers.
Steel mesh benefits: Compared with traditional handmade steel mesh, steel mesh has better elasticity and even spacing. When pouring concrete, the steel mesh is not easy to bend, and the thickness of concrete protective layer is easy to control and even. In bridge deck surfacing, measure the protective layer of steel mesh. The pass rate is 95 percent.
Steel mesh factory – improve the quality of reinforcement works. Electric welding wire mesh is produced by automatic intelligent production line under strict quality control in the factory. Strict control of mesh size, reinforcement specifications and quality. The omission of manual binding net is avoided, and the binding part is firm.
Post time: 28-07-22
Excellent anticorrosive makes its popularity in the feed, the net surface smooth and tidy, increased the look and feel, can be adornment effect, this characteristic makes it to show in the mining industry, due to high quality with low carbon materials as raw materials, to make it unique general iron mesh screen does not have flexibility, determine its plasticity in use process, Thus can be used in the hardware process of deep processing and manufacturing, complex wall batch swing, underground leakage prevention cracking, light mesh body, so that the cost is much lower than the cost of iron screen, more able to understand its economic and practical.
In the use of time do not need to carry out daily maintenance and maintenance, not only can save a lot of time, but also can reduce the cost, but also has good stability, strong corrosion resistance, greatly prolong the service life. According to the different process is divided into different kinds, can be selected according to their own needs, has good flexibility and elasticity. The main role of annealing wire is to control its degree of hardness and softness. When making annealing wire, it is made of steel wire.
Post time: 13-06-24