what are chemical anchors

Post time: 21-12-22
The iron is clean and clean, and then solvent treatment, after drying immersed in zinc liquid, iron and molten zinc reaction to produce an alloyed zinc layer, the process is: degreasing – washing – pickling – assisted plating – drying – hot dip galvanizing – separation – cooling passivation. The thickness of the alloy layer of hot plating wire mainly depends on the chemical composition of the steel silicon content, the size of the steel cross-sectional area, the roughness of the steel surface, the temperature of the zinc pot, the time of dipping zinc, cooling speed, cold rolling deformation, etc.
2.25*2.25mm means that the two strands are 2.25mm silk, and the barbed wire is also 2.25mm silk;
5, the concentration of plating aid can not be too high, which is a factor that can not be ignored to reduce zinc consumption. The concentration of plating aid should not be too high. The galvanized line must be added with ammonium chloride and zinc chloride according to the data of laboratory analysis, and the specific gravity of the composite solution should be controlled within the range of 50~80g/L. If ammonium chloride or zinc chloride is arbitrarily added without the results of laboratory analysis, it should be criticized and educated, and economic treatment should be given if necessary.
The advantages of hexagonal net to do jet hanging net, the first is that the processing speed is fast, the cost is low, and it is very good to roll out when it is open because of the edge. Common specifications: 12 cm x15 cm (11cm x11 cm) 11 cm x15 cm (10 cm x10 cm) 10 cm x12 cm (9 cm x9 cm) 9 cm x13 cm (9 cm x9 cm) 8 cm x10 cm (7 cm x7 cm) common wire: 1.3mm 1.4mm 1.5mm 1.6mm 1.7mm 1.8mm 2.0mm 2.3mm 2.5mm Commonly used materials: galvanized wire hot dip galvanized wire to wire drawn zinc aluminum alloy plastic coated wire stainless steel wire.
The hot dip galvanized hexagonal net is made of low carbon steel wire by mechanized braided welding and then by hot dip zinc treatment. Net color bright white, thick zinc layer, uniform mesh, mesh surface smooth, solder joint tensile resistance, high corrosion resistance.
Aliases: Gabion mesh, heavy hexagonal mesh, ecological mesh, wire mesh, etc.
Post time: 08-02-23
Fourth, the difference between 201 and 304 is the problem of nickel. And the price of 304 is relatively expensive now, generally close to 20,000 yuan per ton, but 304 can at least ensure that it will not rust in the process of use. (Experiment with potions)
Post time: 03-01-23
General birds with a more dense small cage can be. Parrots, crossbilled birds and other large, special beak type hard food birds, to use a metal cage or bird rack.
The national standard on the use of wire mesh standards have certain requirements, diameter and mesh size matching use, rather than simply diameter size, on the plaster layer to use is mesh should not be greater than 20×20, diameter is not easy to be less than 1mm, light selection diameter is not much significance, choose 40×40×0.9 and choose 10×10×0.6 wire mesh, Which is better, I’m afraid is 10×10×0.6.
Cold wire drawing is a kind of cold processing of metal, that is, we often say reinforcement. Cold drawing process is not messy, cold drawing price based on the quality of cold drawing dividends of different levels, cold drawing production is also a variety of different procedures. The main factor affecting the strength of cold drawing wire is raw materials, which are closely related to the raw materials, strength and diameter of raw materials, and the better the quality of cold drawing wire, the more messy the production process.
Post time: 08-05-23
There are various specifications of barbed rope, which can be divided into two categories: ordinary barbed rope and blade barbed rope.
Most people in addition to pay attention to the price of barbed rope, many people for hot-dip galvanized barbed rope or cold galvanized barbed rope will have questions, in fact, these two products, the price difference is not very big, so how to choose hot-dip galvanized barbed rope and electric galvanized barbed rope?
1, stress relief before plating where the maximum tensile strength is greater than 1034Mpa key and important parts before plating should be at 200±10℃ stress relief for more than 1 hours, carburizing or surface quenching parts should be at 140±10℃ stress relief for more than 5 hours.
Are you familiar with galvanized wire mesh? Do you know what to pay attention to in the process of use?
Packaging and binding electric galvanized wire is in the state of liquid zinc, after messy physical and chemical effects, not only on the steel plating thicker pure zinc layer, and also generate a zinc – iron alloy layer. This plating method not only has the corrosion resistance characteristics of galvanized wire, but also has a zinc-iron alloy layer. It also has strong corrosion resistance that can not be compared with galvanizing. Therefore, this plating method is especially suitable for all kinds of strong acid, alkali fog and other strong corrosion environment.

Heavy duty hexagonal mesh made of steel wire by special machinery woven into a hexagonal mesh net. This kind of mesh can be cut and assembled into fence mesh, mountain hanging mesh, vegetation three-dimensional mesh, composite, etc. Aliases: Gabion mesh, heavy hexagonal mesh, ecological mesh, wire mesh, etc.
1. Put the cat carefully in the special basin for washing the cat. Keep your cat as calm as possible.
Poor pretreatment before plating; Bath temperature is too low; Poor quality of additives or too many additives and organic impurities will cause poor bonding. The quality of additives also has an effect on coating foaming. Some additives react incompletely during synthesis and continue to polymerize during long-term storage or use. The additive tends to distort the crystal lattice and cause stress, causing the coating to bubble.
Post time: 27-10-22
The tensile resistance of welding net to 120N, otherwise for unqualified welding net. In this respect, there is no simple way to test the tensile resistance of the welding net, only through professional tools, expert testing to test, we will not introduce in detail. The outcrop on both sides of the welding net should not exceed 2MM. The welding net diameter wire and weft wire crossing place should be welded firmly, but the edge of the welding net to weld firmly weft wire must come out some, to weld firmly, but can not come out too much, generally not more than 2 mm is qualified welding net.
In order to remove the photosynovium and oxide remaining on the surface of galvanized iron wire after drawing or heat treatment, it is necessary to do the surface treatment of galvanized steel wire before plating. The common surface of low carbon steel wire is the light synovium or oxide of animal or vegetable oil; Medium and high carbon steel in addition to contain animal or vegetable oil components.
Iron has gray iron, white iron and the above – mentioned combination of gold, each of which has different characteristics, so in industry, according to their different characteristics to transport and selection. For example, in gray iron, its carbon exists in iron ore as graphite, and the crack is often gray, soft and tough, simple filter cutting, which is suitable for casting.
The external environment has great influence on the preservation of galvanized wire mesh. In the rainy season, it is necessary to pay attention to the air humidity of the workshop, warehouse and other departments. It is recommended to use a humidifier. Usually, the moisture absorption of book paper is larger than that of powder paper, and the pH value is higher. Generally speaking, in the normal environment of storage wire, storage time of two years is not corroded wire phenomenon. However, it should be noted that in the process of handling the iron wire, it should be handled gently to avoid the position of the coiling coil, which will cause the smooth pulling of the wire and affect the production.
Since nose touching is an important part of dogs’ social behavior, humans can use this to train them. Experts say that if owners touch their dogs’ noses often when they are young, they will grow up to have softer personalities and be far less likely to hurt people.
1. Choose according to the size of your dog
Post time: 09-09-22
Unless the stainless steel blade barbed rope is specially customized, it is usually produced by the mould with the knife length of 22mm, which is the BTO-22 type we usually call. This is not necessarily the specification from 11mm to 65mm are specifications. Unless the customer insists on customized length requirements, the barbed rope manufacturer will produce BTO-22 stainless steel blade barbed rope.