Moreover, their versatility is another key selling point. They can be used in a wide range of soil conditions, from soft to hard, and in both onshore and offshore applications They can be used in a wide range of soil conditions, from soft to hard, and in both onshore and offshore applications
- The last is the size of the barbed rope or blade barbed rope. The commonly used size is good, especially for some special-shaped products, which need to be mentioned repeatedly in the production process of the barbed rope factory to avoid unnecessary losses.
In the installation of barbed rope, it is easy to cause incomplete stretch caused by winding, and the installation effect is not very good. At this time, it is necessary to use tensioner for stretching.
- The most obvious gap in a short period of time is the cross section of this piece, hot dip galvanized wire because it is surface anti-corrosion treatment, so in the cross section of this piece will appear rust, and stainless steel wire because the internal raw materials and surface raw materials are consistent, so there is no such situation.
The use of electric welding mesh is very wide, can be used in many places. In the field of construction, especially the wall crack, has played a very important role, the traditional construction, is to put on mortar directly onto the wall, after such a long time, will appear fall off and fracture phenomenon, in order to prevent the occurrence of this phenomenon, must use welded wire mesh before rendering, welded wire mesh is fixed to the wall, above the plastering construction, Can ensure that the wall level for a long time, not easy to crack phenomenon.
According to the galvanized iron wire manufacturer, galvanized iron wire is the selection of excellent low carbon steel, through drawing forming, pickling rust removal, high temperature annealing, hot dip galvanized, cooling and other processes. Galvanized iron wire should pay attention to the following points in the use process:
Blade thorn rope because the volume is relatively large so thorn rope factory is used to packaging treatment.
Post time: 29-12-22
Post time: 28-09-22Galvanized wire coating is galvanized, aluminum plated, coated with nylon or plastic, etc. Zinc is divided into thin coating of steel wire after plating and thick coating of galvanized steel wire after drawing. The mechanical properties of thick coating are reduced compared with smooth steel wire rope, which should be used in severe corrosion environment. It is more resistant to corrosion, wear and heat than galvanized wire rope, using the first plating and then drawing method of production. Coated nylon or plastic wire rope is divided into two kinds of coated rope and coated stock after the rope.
- Reverse twist barbed rope: first wrap the barbed wire around the main wire (i.e. a single wire) and then add another wire to twist and weave it into a double strand barbed rope.
One is the frame isolation net, guardrail net with frame, frame using material cold plate belt welded into the square tube, usually 2*3 thickness 1.2 thick, the middle for low carbon steel wire welding mesh, wire diameter can choose another welding aperture can also choose, for example, customers want good quality long service time, you can choose thick wire diameter, small welding aperture, Such mesh is not only high quality, but also long service life, customized mesh and frame after welding, surface treatment to reach the customer needs of goods.
Post time: 17-11-22In the use of time do not need to carry out daily maintenance and maintenance, not only can save a lot of time, but also can reduce the cost, but also has good stability, strong corrosion resistance, greatly prolong the service life. According to the different process is divided into different kinds, can be selected according to their own needs, has good flexibility and elasticity. The main role of annealing wire is to control its degree of hardness and softness. When making annealing wire, it is made of steel wire.
- Five: Spray blade thorn rope specifications: BTO-10, BTO-12, BTO-18, BTO-22, BTO-28, BTO-30, CBT-60, CBT-65
- 5, play; Appreciation and pan touch. Light touch, over time, the cage will naturally precipitate the traces of time and history and vicissitudes of life. This process does not affect the normal use of the cage. However, it is necessary to maintain the cage continuously and not to use it to the end.
Post time: 30-09-22- Galvanizing can be done by zincate galvanizing or chloride galvanizing. Appropriate additives should be used to obtain a coating that meets the requirements of this standard. Light treatment should be carried out after light plating. The parts that need to be dehydrogenated for passivation should be passivated after dehydrogenation. Before passivation, 1%H2SO4 or 1% hydrochloric acid should be applied for activation for 5~15s. Passivation shall be treated with colored chromate unless otherwise specified in the design drawings.
The large hexagonal mesh is called the stone cage net. Stone cage net before delivery, must be folded into a simple surface, packed compressed after delivery. Then put it in the right position to open, and then the block diameter suitable stone into the cage, the cover is tight, and then the various stone cage net and the adjacent stone cage net tied up.
- In the process of using hot-dip galvanized wire, we should do a good job of daily overhaul and maintenance, try to avoid the destruction of the surface galvanized layer, and extend the service life of the wire. In addition to user binding, building special electric galvanized shaft silk production factory can also be used to decorate gardens and buildings, make it more beautiful and have higher taste.
- Because the bundled galvanized wire is endowed with pre-tension, so it has the excellent characteristics of low relaxation value, small stress loss, good stability after loading, not easy to deformation, no fracture, strong elasticity, ordinary steel lines and rebar is difficult to match. The use of advanced galvanized finishing process, therefore, the use of hot-dip galvanized steel wire construction, not only good anti-corrosion performance, and beautiful generous. The product has the characteristics of smooth surface, high dimensional precision, good uniformity of zinc layer and firm adhesion.
Post time: 08-02-23- With a large pickpocket used for steel wire, into the zinc liquid before the surface of the zinc ash stirring; Use a small outlet for galvanized steel wire; Zinc pot steel wire outlet in 30 minutes, with pickpockets back and forth, until the large, floating zinc residue into brown, real zinc ash, zinc ash surface. The extracted zinc ash should be brown yellow real zinc ash, zinc surface, effectively reduce zinc consumption. This is one of the measures to reduce zinc consumption, but it is also a real problem, which has not been solved for many years.
Post time: 08-10-22
Post time: 28-11-22- Because the bundled galvanized wire is endowed with pre-tension, so it has the excellent characteristics of low relaxation value, small stress loss, good stability after loading, not easy to deformation, no fracture, strong elasticity, ordinary steel lines and rebar is difficult to match. The use of advanced galvanized finishing process, therefore, the use of hot-dip galvanized steel wire construction, not only good anti-corrosion performance, and beautiful generous. The product has the characteristics of smooth surface, high dimensional precision, good uniformity of zinc layer and firm adhesion.
Razor blade barbed rope has been widely used in military sites, prisons, government agencies, banks in the world. The walls of living quarters, private homes, villas, fences, doors and Windows, highways, railway guardrail and border lines and other protection and security.
- After a long time of use, it will not rust like the corrosion layer on the surface of hot dip galvanized barbed rope, because the internal material of stainless steel barbed rope is the same as the material on the surface.
Most of the production enterprises or large public places, they can play a defense hook mesh in the choice of time, often will hook mesh quality in position, so galvanized hook mesh this product few people are interested in, but does this show that galvanized hook mesh is not useful?
- In the process of composite plating, it is necessary to stir the plating solution to obtain the composite coating in which the particles dispersed in the matrix metal. Stirring methods include mechanical stirring, air stirring, ultrasonic stirring, bath circulation, etc. In the process of production, the acid activation solution can remove the corrosion products and oxide film on the surface of low carbon steel wire without excessive corrosion on the matrix. Galvanized wire can be used zincate galvanized or chloride galvanized and other processes, appropriate additives should be used to obtain the coating required by the standards of low carbon steel wire.
Iron and steel in the condition of cooling on the surface galvanized, and hot dip galvanized steel pipe in the condition of hot dip on the surface, its adhesion is strong, not easy to fall off, hot dip galvanized pipe although also rust phenomenon, but in a long period can meet the technical and sanitary requirements.